| 数据搜索系统,热门电子元器件搜索 |
|
ZUSBOPTSC01ZAC 数据表(PDF) 137 Page - Zilog, Inc. |
|
|
|||||||||||||||||||||||||||||
ZUSBOPTSC01ZAC 数据表(HTML) 137 Page - Zilog, Inc. |
|
137 / 402 page ![]() PS024604-1005 P R E L I M I N A R Y Receiving Data using the Polled Method Z8FMC16100 Series Flash MCU Product Specification 115 7. Execute an EI instruction to enable interrupts. The LIN-UART is now configured for interrupt-driven data transmission. Because the LIN-UART Transmit Data Register is empty, an interrupt is generated immediately. When the LIN-UART Transmit interrupt is detected, and there is transmit data ready to send, the associated interrupt service routine (ISR) performs the following: 1. If in MULTIPROCESSOR mode, write the LIN-UART Control 1 Register to select the outgoing address bit: Set the Multiprocessor Bit Transmitter (MPBT) if sending an address byte, clear it if sending a data byte. 2. Write the data byte to the LIN-UART Transmit Data Register. The transmitter auto- matically transfers the data to the Transmit Shift register and transmits the data. 3. Execute the IRET instruction to return from the interrupt-service routine and wait for the Transmit Data Register to again become empty. If a transmit interrupt occurs and there is no transmit data ready to send the interrupt-ser- vice routine will execute the IRET instruction. When the application does have data to transmit, software can set the appropriate interrupt request bit in the Interrupt Controller to initiate a new transmit interrupt. Another alternative would be for software to write the data to the Transmit Data Register instead of invoking the interrupt-service routine. Receiving Data using the Polled Method Follow these steps to configure the LIN-UART for polled data reception: 1. Write to the LIN-UART Baud Rate High and Low Byte registers to set the appropriate baud rate. 2. Enable the LIN-UART pin functions by configuring the associated GPIO port pins for alternate function operation. 3. Write to the LIN-UART Control 1 Register to enable MULTIPROCESSOR mode functions, if appropriate. 4. Write to the LIN-UART Control 0 Register to: a. Set the receive enable bit (REN) to enable the LIN-UART for data reception b. If multiprocessor mode is not enabled, enable parity, if appropriate, and select either even or odd parity. 5. Check the RDA bit in the LIN-UART Status 0 register to determine if the Receive Data Register contains a valid data byte (indicated by a 1). If RDA is set to 1 to indicate available data, continue to Step 6. If the Receive Data Register is empty (indicated by a 0), continue to monitor the RDA bit awaiting reception of the valid data. |
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |