JS28F256P33BFE datasheet(22/90 Pages) MICRON

22 / 90 page

P33-65nm

Datasheet

Aug 2009

Order Number: 320003-08

• Figure 21, “Continuous Burst Read, showing an Output Delay Timing” on page 53

• Figure 22, “Synchronous Burst-Mode Four-Word Read Timing” on page 54

7.3

Read Device Identifier

The Read Device Identifier command instructs the device to output manufacturer code,

device identifier code, block-lock status, OTP register data, or configuration register

data (see Section 6.2, “Device Command Bus Cycles” on page 18 for details on issuing

the Read Device Identifier command). Table 8, “Device Identifier Information” on

page 22 and Table 9, “Device ID codes” on page 22 show the address offsets and data

values for this device.

7.4

Read CFI

The Read CFI command instructs the device to output Common Flash Interface data

when read.

Table 8:

Device Identifier Information

Item

Address(1,2)

Data

Manufacturer Code

0x00

0x89h

Device ID Code

0x01

ID (see

Table 9)

Block Lock Configuration:

BBA + 0x02

Lock Bit:

• Block Is Unlocked

DQ0 = 0b0

• Block Is Locked

DQ0 = 0b1

• Block Is not Locked-Down

DQ1 = 0b0

• Block Is Locked-Down

DQ1 = 0b1

Read Configuration Register

0x05

RCR Contents

General Purpose Register(3)

DBA + 0x07

general data

Lock Register 0

0x80

PR-LK0

64-bit Factory-Programmed OTP register

0x81–0x84

Factory OTP register data

64-bit User-Programmable OTP Register

0x85–0x88

User OTP register data

Lock Register 1

0x89

OTP register lock data

128-bit User-Programmable OTP registers

0x8A–0x109

User OTP register data

Notes:

BBA = Block Base Address.

DBA = Device base Address, Numonyx reserves other configuration address locations

In P33-65nm, the GPR is used as read out register for Extended Functional interface command.

Table 9:

Device ID codes

ID Code Type

Device Density

Device Identifier Codes

–T

(Top Parameter)

–B

(Bottom Parameter)

Device Code

256-Mbit

891F

8922

Note:

The 512-Mbit devices do not have a Device ID associated with them. Each die within the stack can be identified by either

of the 256-Mbit Device ID codes depending on its parameter option.

JS28F256P33BFE 数据表(PDF) 22 Page - Micron Technology

JS28F256P33BFE 数据表(HTML) 22 Page - Micron Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90

数据表下载