STM8S datasheet(392/467 Pages) STMICROELECTRONICS

392 / 467 page

Controller area network (beCAN)

RM0016

392/467

DocID14587 Rev 14

Filter match index

Once a message has been received in the FIFO it is available to the application. Typically

application data are copied into RAM locations. To copy the data to the right location the

application has to identify the data by means of the identifier. To avoid this and to ease the

access to the RAM locations, the CAN controller provides a Filter Match Index.

This index is stored in the mailbox together with the message according to the filter priority

rules. Thus each received message has its associated Filter Match Index.

The Filter Match Index can be used in two ways:

–

Compare the Filter Match Index with a list of expected values.

–

Use the Filter Match Index as an index on an array to access the data destination

location.

For non-masked filters, the software no longer has to compare the identifier.

If the filter is masked the software reduces the comparison to the masked bits only.

Note:

The index value of the filter number does not take into account the activation state of the

filter banks.

Table 65. Example of filter numbering

Filter bank

Filter number

Number

FCS

FMH

FML

FACT

Configuration

0b11

Identifier list (32-bit)

0b11

Identifier mask (32-bit)

0b10

Identifier list (16-bit)

0b00

Deactivated

Identifier List/Identifier

mask (8-bit)

0b10

Deactivated

Identifier Mask (16-bit)

0b01

Identifier Mask (16/8-bit)

STM8S 数据表(PDF) 392 Page - STMicroelectronics

STM8S 数据表(HTML) 392 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载