Z8F021ASH020SC datasheet(85/276 Pages) ZILOG

85 / 276 page

PS022815-0206

Timers

Z8 Encore! XP® 4K Series

Product Specification

–

Select either the rising edge or falling edge of the Timer Input signal for the count.

This selection also sets the initial logic level (High or Low) for the Timer Output

alternate function. However, the Timer Output function is not required to be

enabled.

2. Write to the Timer High and Low Byte registers to set the starting count value. This

only affects the first pass in COUNTER mode. After the first timer Reload in

COUNTER mode, counting always begins at the reset value of 0001H. In COUNTER

mode the Timer High and Low Byte registers must be written with the value 0001H.

3. Write to the Timer Reload High and Low Byte registers to set the Reload value.

4. If appropriate, enable the timer interrupt and set the timer interrupt priority by writing

to the relevant interrupt registers.

5. Configure the associated GPIO port pin for the Timer Input alternate function.

6. If using the Timer Output function, configure the associated GPIO port pin for the

Timer Output alternate function.

7. Write to the Timer Control register to enable the timer.

In COUNTER mode, the number of Timer Input transitions since the timer start is given

by the following equation:

COMPARATOR COUNTER Mode

In COMPARATOR COUNTER mode, the timer counts input transitions from the analog

comparator output. The TPOL bit in the Timer Control Register selects whether the count

occurs on the rising edge or the falling edge of the comparator output signal. In COMPAR-

ATOR COUNTER mode, the prescaler is disabled.

The frequency of the comparator output signal must not exceed one-fourth the system

clock frequency. Further, the high or low state of the comparator output signal pulse

must be no less than twice the system clock period. A shorter pulse may not be captured.

After reaching the Reload value stored in the Timer Reload High and Low Byte registers,

the timer generates an interrupt, the count value in the Timer High and Low Byte registers

is reset to 0001H and counting resumes. Also, if the Timer Output alternate function is

enabled, the Timer Output pin changes state (from Low to High or from High to Low) at

timer Reload.

The steps for configuring a timer for COMPARATOR COUNTER mode and initiating the

count are as follows:

1. Write to the Timer Control register to:

–

Disable the timer

Counter Mode Timer Input Transitions

Current Count Value Start Value

–

Caution:

Z8F021ASH020SC 数据表(PDF) 85 Page - Zilog, Inc.

Z8F021ASH020SC 数据表(HTML) 85 Page - Zilog, Inc.

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载