Z8F021ASH020SC datasheet(201/276 Pages) ZILOG

201 / 276 page

PS022815-0206

Oscillator Control

Z8 Encore! XP® 4K Series

Product Specification

182

When selecting a new clock source, the system clock oscillator failure detection circuitry

and the Watch-Dog Timer oscillator failure circuitry must be disabled. If SOFEN and

WOFEN are not disabled prior to a clock switch-over, it is possible to generate an inter-

rupt for a failure of either oscillator. The Failure detection circuitry can be enabled any-

time after a successful write of OSCSEL in the OSCCTL register.

The internal precision oscillator is enabled by default. If the user code changes to a differ-

ent oscillator, it may be appropriate to disable the IPO for power savings. Disabling the

IPO does not occur automatically.

Clock Failure Detection and Recovery

System Clock Oscillator Failure

The Z8F04xA family devices can generate non-maskable interrupt-like events when the

primary oscillator fails. To maintain system function in this situation, the clock failure

recovery circuitry automatically forces the Watch-Dog Timer oscillator to drive the system

clock. The Watch-Dog Timer oscillator must be enabled to allow the recovery. Although

this oscillator runs at a much slower speed than the original system clock, the CPU contin-

ues to operate, allowing execution of a clock failure vector and software routines that

either remedy the oscillator failure or issue a failure alert. This automatic switch-over is

not available if the Watch-Dog Timer is selected as the system clock oscillator. It is also

unavailable if the Watch-Dog Timer oscillator is disabled, though it is not necessary to

enable the Watch-Dog Timer reset function outlined in the Watch-Dog Timer chapter of

this document on page 83.

The primary oscillator failure detection circuitry asserts if the system clock frequency

drops below 1KHz ±50%. If an external signal is selected as the system oscillator, it is

possible that a very slow but non-failing clock can generate a failure condition. Under

these conditions, do not enable the clock failure circuitry (SOFEN must be deasserted in

the OSCCTL register).

Watch-Dog Timer Failure

In the event of a Watch-Dog Timer oscillator failure, a similar non-maskable interrupt-like

event is issued. This event does not trigger an attendant clock switch-over, but alerts the

CPU of the failure. After a Watch-Dog Timer failure, it is no longer possible to detect a

primary oscillator failure. The failure detection circuitry does not function if the Watch-

Dog Timer is used as the system clock oscillator or if the Watch-Dog Timer oscillator has

been disabled. For either of these cases, it is necessary to disable the detection circuitry by

deasserting the WDFEN bit of the OSCCTL register.

The Watch-Dog Timer oscillator failure detection circuit counts system clocks while look-

ing for a Watch-Dog Timer clock. The logic counts 8004 system clock cycles before deter-

mining that a failure has occurred. The system clock rate determines the speed at which

Z8F021ASH020SC 数据表(PDF) 201 Page - Zilog, Inc.

Z8F021ASH020SC 数据表(HTML) 201 Page - Zilog, Inc.

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载