| 数据搜索系统,热门电子元器件搜索 |
|
TUSB3200CPAH 数据表(PDF) 35 Page - Texas Instruments |
|
|
|||||||||||||||||||||||||||||
TUSB3200CPAH 数据表(HTML) 35 Page - Texas Instruments |
|
35 / 93 page ![]() 2–19 be generated by the TUSB3200 device, should be a frequency of 24.576 MHz. The start of each 48-kHz frame is synchronized to the rising edge of the SYNC signal, which is an output of the TUSB3200 device. The SYNC signal is driven high each frame for the duration of slot 0. See Figure 2–2 for details on connecting the TUSB3200 to a CODEC device in this mode. MCLKO CSYNC CSCLK CDATO CDATI CRESET CSCHNE AC97CLK SYNC BIT_CLK SD_IN SD_OUT CRESET TUSB3200 AC’97 IC Figure 2–2. Connection of the TUSB3200 to an AC ’97 CODEC The AC link protocol defines slot 0 as a special slot called the tag slot and defines slots 1 through 12 as data slots. Slot 1 and slot 2 are used to transfer command and status information between the TUSB3200 device and the CODEC. Slot 1 and slot 2 of the outgoing serial data stream are defined as the command address and command data slots, respectively. These slots are used for writing to the control registers in the CODEC. Slot 1 and slot 2 of the incoming serial data stream are defined as the status address and status data slots, respectively. These slots are used for reading from the control registers in the CODEC. Unused or reserved time slots and unused bit locations within a valid time slot are filled with zeros. Since each data time slot is 20 bits in length, the protocol supports 8-bit, 16-bit, 18-bit or 20-bit data transfers. 2.2.13.2 Audio CODEC (AC) ’97 2.0 Mode of Operation The basic serial protocol for the AC ’97 2.0 mode is the same as the AC ’97 1.0 mode. The AC ’97 2.0 mode, however, offers some additional features. In this mode, the TUSB3200 provides support for multiple CODEC devices and also on-demand sampling. The TUSB3200 can connect directly to two AC ’97 CODECs as shown in Figure 2–3. Note that if only one CODEC is used, then the SD_IN2 input (pin 40) should be tied to DVSS. Table 2–4. Terminal Assignments for CODEC Port Interface AC ’97 2.0 Mode TERMINAL AC ’97 Version 2.0 NO. NAME MODE 3 35 CSYNC SYNC O 34 CSCLK BIT_CLK I 36 CDATO SD_OUT O 38 CDATI SD_IN1 I 39 CRESET RESET O 40 CSCHNE SD_IN2 I |
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |