TUSB3200CPAH datasheet(49/93 Pages) TI

49 / 93 page

A–1

Appendix A

MCU Memory and Memory-Mapped Registers

This section describes the TUSB3200 MCU memory configurations and operation. In general, the MCU memory

operation is the same as the industry standard 8052 MCU.

A.1 MCU Memory Space

The TUSB3200 MCU memory is organized into three individual spaces: program memory, external data memory and

internal data memory. The total address range for the program memory and the external data memory spaces is 64K

bytes each. The total address range for the internal data memory is 256 bytes.

The read only program memory contains the instructions to be executed by the MCU. The TUSB3200 uses a 4K boot

ROM as the program memory during initialization. The boot ROM program code will download the application

program code from a nonvolatile memory (i.e., EEPROM) on the peripheral PCB. The application program code will

be written to an 8K RAM mapped to the external data memory space. After downloading the application program code

to RAM, the boot ROM will enable the normal operating mode by setting the ROM disable (SDW) bit (refer to memory

configuration register) to enable program code execution from the 8K RAM instead of the boot ROM. In the normal

operating mode, the boot ROM is still mapped to program memory space starting at address 8000h. Refer to Figures

A–1 and A–2 for details.

The external data memory contains the data buffers for the USB endpoints, the configuration blocks for the USB

endpoints, the setup data packet buffer for the USB control endpoint, and memory mapped registers. The data buffers

for the USB endpoints, the configuration blocks for the USB endpoints and the setup data packet buffer for the USB

control endpoint are all implemented in RAM. The memory mapped registers used for control and status registers

are implemented in hardware with flip-flops. The data buffers for the USB endpoints are a total of 1832 bytes, the

configuration blocks for the USB endpoints are a total of 128 bytes, the setup packet buffer for the USB control

endpoint is 8 bytes and the memory mapped registers space is 80 bytes. The total external data memory space used

for these blocks of memory is 2K bytes. In addition to these memory blocks, an 8K RAM is mapped to the external

data memory space in the boot loader mode of operation. The 8K RAM is read/write in this mode and is used to store

the application program code during download by the boot ROM. In the normal mode of operation, the 8K RAM is

mapped to the program memory space and is read only.

TUSB3200CPAH 数据表(PDF) 49 Page - Texas Instruments