ADAU1772BCPZ-R7 datasheet(60/117 Pages) AD

60 / 117 page

Data Sheet

ADAU1772

Rev. C | Page 59 of 116

FILTER ENGINE AND LIMITER CONTROL REGISTER

Address: 0x000B, Reset: 0x03, Name: CORE_ENABLE

Disabling the limiter only disables the attack operation. The decay operation is always active, so a limiter can be safely disabled while it

performs gain adjustments.

Table 40. Bit Descriptions for CORE_ENABLE

Bits

Bit Name

Settings

Description

Reset

Access

LIM_EN

Limiter enable. When the limiter function is disabled, a fixed max gain

setting is applied to instructions using the limiters.

0x1

Disabled

Enabled

DSP_CLK_EN

Enable the clock to the core. Directly controls the clock to the core. It should

be set to 0 when the chip is used in a codec-only configuration, in which the

core is not used. Writing to any of the biquad coefficient registers (Parameter

Memory Address 0x0E0 to Address 0x2BF) is blocked until this bit is 1. This

bit should not be used to start or stop the core while it is running, because

it would immediately start or stop the core clock and not allow the program

to finish. Instead, use CORE_RUN in Register CORE_CONTROL to start or

stop the core.

0x1

Core clock disabled

Core clock enabled

ADAU1772BCPZ-R7 数据表(PDF) 60 Page - Analog Devices