Z8F021ASH020SC datasheet(168/276 Pages) ZILOG

168 / 276 page

PS022815-0206

Flash Option Bits

Z8 Encore! XP® 4K Series

Product Specification

149

Option Bit Types

User Option Bits

The user option bits are contained in the first two bytes of program memory. User access

to these bits has been provided because these locations contain application-specific device

configurations. The information contained here is lost when page 0 of the program mem-

ory is erased.

Trim Option Bits

The trim option bits are contained in the information page of the Flash memory. These bits

are factory programmed values required to optimize the operation of onboard analog cir-

cuitry and cannot be permanently altered by the user. Program memory may be erased

without endangering these values. It is possible to alter working values of these bits by

accessing the Trim Bit Address and Data Registers, but these working values are lost after

a power loss or any other reset event.

There are 32 bytes of trim data. To modify one of these values the user code must first

write a value between 00H and 1FH into the Trim Bit Address Register. The next write to

the Trim Bit Data register changes the working value of the target trim data byte.

Reading the trim data requires the user code to write a value between 00H and 1FH into the

Trim Bit Address Register. The next read from the Trim Bit Data register returns the work-

ing value of the target trim data byte.

The trim address range is from information address 20-3F only. The remainder of the

information page is not accessible through the trim bit address and data registers.

Calibration Option Bits

The calibration option bits are also contained in the information page. These bits are fac-

tory programmed values intended for use in software correcting the device’s analog per-

formance. To read these values, the user code must employ the LDC instruction to access

the information area of the address space as defined in See Flash Information Area on

page 15.

Serialization Bits

As an optional feature, ZiLOG is able to provide factory-programmed serialization. For

serialized products, the individual devices will be programmed with unique serial num-

bers. These serial numbers are binary values, four bytes in length. The numbers increase in

size with each device, but gaps in the serial sequence may exist.

These serial numbers are stored in the flash information page (see Reading the Flash Infor-

mation Page on page 150 and Serialization Data on page 159 for more details) and are

unaffected by mass erasure of the device's flash memory.

Note:

Z8F021ASH020SC 数据表(PDF) 168 Page - Zilog, Inc.

Z8F021ASH020SC 数据表(HTML) 168 Page - Zilog, Inc.

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载