ADE5166 datasheet(126/148 Pages) AD

126 / 148 page

ADE5166/ADE5169/ADE5566/ADE5569

Preliminary Technical Data

Rev. PrB | Page 126 of 148

TCLK puts Timer 2 into its baud rate generator mode, as shown

in Figure 85.

In this case, the baud rate is given by the following formula:

Mode 1 or Mode 3 Baud Rate

()

[]

()

RCAP

CORE

65536

−

UART Timer Generated Baud Rates

The high integer dividers in a UART block mean that high speed

baud rates are not always possible. In addition, generating baud

rates requires the exclusive use of a timer, rendering it unusable

for other applications when the UART is required. To address

this problem, each ADE5166/ADE5169/ADE5566/ADE5569

has a dedicated baud rate timer (UART timer) specifically for

generating highly accurate baud rates. The UART timer can be

used instead of Timer 1 or Timer 2 for generating very accurate

high speed UART baud rates, including 115,200 bps. This timer

also allows a much wider range of baud rates to be obtained. In

fact, every desired bit rate from 12 bps to 393,216 bps can be

generated to within an error of ±0.8%. The UART timer also

frees up the other three timers, allowing them to be used for

different applications. A block diagram of the UART timer is

shown in Figure 84.

÷(1 + SBAUDF/64)

UART TIMER

Rx/Tx CLOCK

fCORE

UARTBAUDEN

Rx CLOCK

Tx CLOCK

TIMER 1/TIMER 2

Rx CLOCK

FRACTIONAL

DIVIDER

TIMER 1/TIMER 2

Tx CLOCK

÷32

÷2DIV + SBTH

Figure 84. UART Timer, UART Baud Rate

Two SFRs, enhanced serial baud rate control SFR (SBAUDT,

0x9E) and UART timer fractional divider SFR (SBAUDF, 0x9D),

are used to control the UART timer. SBAUDT is the baud rate

control SFR; it sets up the integer divider (DIV) and the extended

divider (SBTH) for the UART timer.

The appropriate value to write to the DIV[2:0] and SBTH[1:0]

bits can be calculated using the following formula where fCORE is

defined in the POWCON SFR (see Table 25). Note that the DIV

value must be rounded down to the nearest integer.

()

log

⎟

⎠

⎞

⎜

⎝

⎛

Rate

Baud

SBTH

DIV

CORE

fCORE

TR2

CONTROL

TL2

(8 BITS)

TH2

(8 BITS)

RELOAD

EXEN2

CONTROL

T2EX

TRANSITION

DETECTOR

EXF 2

TIMER 2

INTERRUPT

RCAP2L

RCAP2H

TIMER 2

OVERFLOW

RCLK

TCLK

CLOCK

SMOD

TIMER 1

OVERFLOW

C/ T2 = 0

C/ T2 = 1

NOTE: AVAILABILITY OF ADDITIONAL

EXTERNAL INTERRUPT

Figure 85. Timer 2, UART Baud Rates

ADE5166 数据表(PDF) 126 Page - Analog Devices

ADE5166 数据表(HTML) 126 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载