CY8CKIT-059 datasheet(66/140 Pages) INFINEON

66 / 140 page

Document Number: 001-84932 Rev. *N

Page 65 of 139

PSoC® 5LP: CY8C58LP Family

Datasheet

9.8 CSP Package Bootloader

A factory-installed bootloader program is included in all devices

with CSP packages. The bootloader is compatible with PSoC

Creator 3.0 bootloadable project files, and has the following

features:



I2C-based



SCLK and SDAT available at P1[6] and P1[7], respectively



External pull-up resistors required



I2C slave, address 4, data rate = 100 kbps



Single application



Wait 2 seconds for bootload command



Other bootloader options are as set by the PSoC Creator 3.0

Bootloader Component default



Occupies the bottom 9 Kbytes of flash

For more information on this bootloader, see the following

Cypress application notes:



AN73854, PSoC 3 and PSoC 5 LP Introduction to Bootloaders



AN60317, PSoC 3 and PSoC 5 LP I2C Bootloader

Note that a PSoC Creator bootloadable project must be

associated with .hex and .elf files for a bootloader project that is

configured for the target device. Bootloader .hex and .elf files

can be found at www.cypress.com/go/PSoC5LPdatasheet.

The factory-installed bootloader can be overwritten using JTAG

or SWD programming.

CY8CKIT-059 数据表(PDF) 66 Page - Infineon Technologies AG

CY8CKIT-059 数据表(HTML) 66 Page - Infineon Technologies AG

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载