TNETV2840ENGGU datasheet(36/91 Pages) TI1

36 / 91 page

Functional Overview

December 1999 − Revised October 2008

SPRS122F

3.2.2.4

HPI Nonmultiplexed Mode

In nonmultiplexed mode, a host with separate address/data buses can access the HPI16 data register (HPID)

via the 16-bit HD bidirectional data bus, and the address register (HPIA) via the 19-bit HA address bus. The

HA[18] signal is used to make selection between program (shared) memory and data (local) memory access.

Table 3−4 shows the memory selection via HA[18].

Table 3−4. HPI Local/Shared Memory Selection Via HA[18]

HA[18]

Memory Type

Local (data)

Shared (program)

The host initiates the access with the strobe signals (HDS1, HDS2, and HCS) and controls the direction of

the access with the HR/W signal. The HPI16 can stall host accesses via the HRDY signal. Note that the HPIC

initiate a DMA read or write access. Figure 3−12 shows a block diagram of the HPI16 in nonmultiplexed mode.

HOST

HPI-16

Data[15:0]

HD[15:0]

R/W

HR/W

Data strobes

HDS1, HDS2, HCS

HRDY

Ready

HPID[15:0]

DMA

C54x

CPU

Address[n:0]†

HA[n :0]†

† n = 0 to 18

Figure 3−12. Interfacing to the HPI-16 in Non-Multiplexed Mode

TNETV2840ENGGU 数据表(PDF) 36 Page - Texas Instruments

TNETV2840ENGGU 数据表(HTML) 36 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91

数据表下载