H8SSLASH2214 datasheet(270/936 Pages) RENESAS

270 / 936 page

Section 7 DMA Controller

Rev.4.00 Sep. 18, 2008 Page 210 of 872

REJ09B0189-0400

Operation in each mode is summarized below.

(1) Sequential Mode

In response to a single transfer request, the specified number of transfers are carried out, one byte

or one word at a time. An interrupt request can be sent to the CPU or DTC when the specified

number of transfers have been completed. One address is specified as 24 bits, and the other as 16

bits. The transfer direction is programmable.

(2) Idle Mode

In response to a single transfer request, the specified number of transfers are carried out, one byte

or one word at a time. An interrupt request can be sent to the CPU or DTC when the specified

number of transfers have been completed. One address is specified as 24 bits, and the other as 16

bits. The transfer source address and transfer destination address are fixed. The transfer direction

is programmable.

(3) Repeat Mode

In response to a single transfer request, the specified number of transfers are carried out, one byte

or one word at a time. When the specified number of transfers have been completed, the addresses

and transfer counter are restored to their original settings, and operation is continued. No interrupt

request is sent to the CPU or DTC. One address is specified as 24 bits, and the other as 16 bits.

The transfer direction is programmable.

(4) Normal Mode

• Auto-request

By means of register settings only, the DMAC is activated, and transfer continues until the

specified number of transfers have been completed. An interrupt request can be sent to the

CPU or DTC when transfer is completed. Both addresses are specified as 24 bits.

⎯ Cycle steal mode: The bus is released to another bus master every byte or word transfer.

⎯ Burst mode: The bus is held and transfer continued until the specified number of transfers

have been completed.

• External request

In response to a single transfer request, the specified number of transfers are carried out, one

byte or one word at a time. An interrupt request can be sent to the CPU or DTC when the

specified number of transfers have been completed. Both addresses are specified as 24 bits.

H8S/2214 数据表(PDF) 270 Page - Renesas Technology Corp