H8SSLASH2214 datasheet(273/936 Pages) RENESAS

273 / 936 page

Section 7 DMA Controller

Rev.4.00 Sep. 18, 2008 Page 213 of 872

REJ09B0189-0400

Transfer requests (activation sources) consist of external requests, SCI transmission complete and

reception complete interrupts, and TPU channel 0 to 2 compare match/input capture A interrupts.

External requests can be set for channel B only.

Figure 7.4 shows an example of the setting procedure for sequential mode.

Sequential mode setting

Set DMABCRH

Set transfer source

and transfer destination

addresses

Set number of transfers

Set DMACR

Read DMABCRL

Set DMABCRL

Sequential mode

[1]

[2]

[3]

[4]

[5]

[6]

[1] Set each bit in DMABCRH.

• Clear the FAE bit to 0 to select short address

mode.

• Specify enabling or disabling of internal

interrupt clearing with the DTA bit.

[2] Set the transfer source address and transfer

destination address in MAR and IOAR.

[3] Set the number of transfers in ETCR.

[4] Set each bit in DMACR.

• Set the transfer data size with the DTSZ bit.

• Specify whether MAR is to be incremented or

decremented with the DTID bit.

• Clear the RPE bit to 0 to select sequential

mode.

• Specify the transfer direction with the DTDIR

bit.

• Select the activation source with bits DTF3 to

DTF0.

[5] Read the DTE bit in DMABCRL as 0.

[6] Set each bit in DMABCRL.

• Specify enabling or disabling of transfer end

interrupts with the DTIE bit.

• Set the DTE bit to 1 to enable transfer.

Figure 7.4 Example of Sequential Mode Setting Procedure

H8S/2214 数据表(PDF) 273 Page - Renesas Technology Corp

H8S/2214 数据表(HTML) 273 Page - Renesas Technology Corp

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载