LSM6DSV datasheet(90/187 Pages) STMICROELECTRONICS

90 / 187 page

9.53

TAP_CFG0 (56h)

Tap configuration register 0 (R/W)

Table 145. TAP_CFG0 register

0(1)

LOW_PASS_

ON_6D

HW_FUNC_MASK

_XL_SETTL

SLOPE_

FDS

TAP_X_EN

TAP_Y_EN

TAP_Z_EN

LIR

1. This bit must be set to 0 for the correct operation of the device.

Table 146. TAP_CFG0 register description

LOW_PASS_ON_6D

LPF2 filter on 6D function selection. Refer to Figure 30. Default value: 0

(0: ODR/2 low-pass filtered data sent to 6D interrupt function;

1: LPF2 output data sent to 6D interrupt function)

HW_FUNC_MASK_XL_SETTL

Enables masking the execution trigger of the basic interrupt functions (6D/4D, free-fall, wake-

up, tap, activity/inactivity) when accelerometer data are settling. Default value: 0

(0: disabled; 1: enabled)

SLOPE_FDS

HPF or slope filter selection on wake-up and activity/inactivity functions. Refer to Figure 30.

Default value: 0

(0: slope filter applied; 1: HPF applied)

TAP_X_EN

Enables X direction in tap recognition. Default value: 0

(0: X direction disabled; 1: X direction enabled)

TAP_Y_EN

Enables Y direction in tap recognition. Default value: 0

(0: Y direction disabled; 1: Y direction enabled)

TAP_Z_EN

Enables Z direction in tap recognition. Default value: 0

(0: Z direction disabled; 1: Z direction enabled)

LIR

Latched interrupt. Default value: 0

(0: interrupt request not latched; 1: interrupt request latched)

LSM6DSV

TAP_CFG0 (56h)

DS13476 - Rev 2

page 90/187

LSM6DSV 数据表(PDF) 90 Page - STMicroelectronics

LSM6DSV 数据表(HTML) 90 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载