LSM6DSV datasheet(35/187 Pages) STMICROELECTRONICS

35 / 187 page

6.6.2

Block diagrams of the gyroscope filters

In the LSM6DSV, the gyroscope filtering chain depends on the mode configuration:

•

Mode 1 (for user interface (UI) and electronic image stabilization (EIS) functionality through primary

interface) and mode 2

Figure 21. Gyroscope digital chain - mode 1 (UI/EIS) and mode 2

ADC

LPF1_G_EN

Digital

LP filter

LPF1_G_BW_[2:0]

LPF1

SPI / I2C /

MIPI I3C

FIFO

Digital

LP filter

ODR_G_[3:0]

LPF2

(1) (2)

FSM

When the gyroscope OIS or EIS chain is enabled, the LPF1 filter is not available in the gyroscope UI chain.

It is recommended to avoid using the LPF1 filter in the gyroscope UI chain when the gyroscope OIS or EIS is

intended to be used.

The LPF1 filter is available in high-performance mode only. If the gyroscope is configured in low-power

mode, the LPF1 filter is bypassed.

In this configuration, the gyroscope ODR is selectable from 7.5 Hz up to 7.68 kHz. A low-pass filter (LPF1) is

available, for more details about the filter characteristics see Table 60. Gyroscope LPF1 bandwidth selection.

The digital LPF2 filter's cutoff frequency depends on the selected gyroscope ODR, as indicated in the following

table.

Table 19. Gyroscope LPF2 bandwidth selection

Gyroscope ODR [Hz]

LPF2 cutoff [Hz]

7.5

3.4

6.6

13.0

24.6

120

240

480

185

960

353

1.92 kHz

491

3.84 kHz

528

7.68 kHz

537

Note:

Data can be acquired from the output registers and FIFO over the primary I²C/MIPI I3C®/SPI interface.

LSM6DSV

Block diagram of filters

DS13476 - Rev 2

page 35/187

LSM6DSV 数据表(PDF) 35 Page - STMicroelectronics

LSM6DSV 数据表(HTML) 35 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载