| 数据搜索系统,热门电子元器件搜索 |
|
PC87570-ICC/VUL 数据表(PDF) 80 Page - National Semiconductor (TI) |
|
|
|
|||||||||||||||||||||||||||||
PC87570-ICC/VUL 数据表(HTML) 80 Page - National Semiconductor (TI) |
|
80 / 168 page ![]() Power Mode Control (PMC) 80 www.national.com 8.4 POWER MODE CONTROL REGISTER (PMCR) The PMCR Register is a byte-wide, read/write register that enables you to switch from Active to Idle mode. In addition, it controls the operation of the HFCG in Idle mode by en- abling or disabling it. The PC87570 enters Idle mode after execution of a WAIT instruction. The PMCR Register must be set before executing the WAIT instruction. Upon reset, the non-reserved bits of PMCR are cleared. Bit 1 - Disable High Frequency Clock Generator (DHF) 0: HFCG remains enabled after entering Idle mode; waking up to Active mode clears this bit 1: HFCG disabled only after WAIT instruction is exe- cuted and Idle mode is entered Bit 2 - IDLE 0: PC87570 remains in Active mode after WAIT in- struction is executed 1: PC87570 can enter Idle mode, depending on set- ting of EIM bit; waking up to Active mode clears this bit Bit 5 - Enable Idle Mode (EIM) 0: Idle mode not enabled 1: Active to Idle mode switch enabled, performed by setting IDLE bit and executing a WAIT instruction. 8.5 USAGE HINTS The hints below apply when you enter Idle mode and dis- able the HFCG. 1. When disabling HFCG in Idle mode, a frequency clock may be generated that differs from the selected setting, due to temperature variations in your working environ- ment. For details, refer to “tCLKINTwk” on page 138. To avoid any failures that may result from waking up to a higher frequency than zone 0 of the External Memory can handle, follow the procedures exactly. Before entering Idle mode, configure SZCFG0 for an ad- ditional Wait clock cycle (see the BIU, Section 3.5.3 on page 45, for details on SZCFG0 configuration). 2. After waking up from Idle mode, wait 0.5 seconds before returning to your previous SZCFG0 configuration. Active Idle Power Off Turn Off Power PMCR.EIM=1 Turn On Power Hardware Event Reset Figure 8-1. Power Modes and Transitions PMCR.IDLE=1 and WAIT 7 6 5 4 3 2 1 0 Reserved EIM Reserved IDLE DHF Res |
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |