H8SX1663 datasheet(4/1158 Pages) RENESAS

4 / 1158 page

Rev.1.00 Jun. 07, 2006 Page iv of lii

General Precautions on Handling of Product

1. Treatment of NC Pins

Note:

Do not connect anything to the NC pins.

The NC (not connected) pins are either not connected to any of the internal circuitry or are

used as test pins or to reduce noise. If something is connected to the NC pins, the

operation of the LSI is not guaranteed.

2. Treatment of Unused Input Pins

Note:

Fix all unused input pins to high or low level.

Generally, the input pins of CMOS products are high-impedance input pins. If unused pins

are in their open states, intermediate levels are induced by noise in the vicinity, a pass-

through current flows internally, and a malfunction may occur.

3. Processing before Initialization

Note:

When power is first supplied, the product's state is undefined.

The states of internal circuits are undefined until full power is supplied throughout the

chip and a low level is input on the reset pin. During the period where the states are

undefined, the register settings and the output state of each pin are also undefined. Design

your system so that it does not malfunction because of processing while it is in this

undefined state. For those products which have a reset function, reset the LSI immediately

after the power supply has been turned on.

4. Prohibition of Access to Undefined or Reserved Addresses

Note:

Access to undefined or reserved addresses is prohibited.

The undefined or reserved addresses may be used to expand functions, or test registers

may have been be allocated to these addresses. Do not access these registers; the system's

operation is not guaranteed if they are accessed.

H8SX1663 数据表(PDF) 4 Page - Renesas Technology Corp