TNETV1002IDZHK datasheet(68/102 Pages) TI1

68 / 102 page

Electrical Specifications

June 2001 -- Revised December 2002

SPRS180C

6.7

Ready Timing for Externally Generated Wait-States

Table 6--12 assumes testing over recommended operating conditions and H = 0.5tc(CO) (see Figure 6--8,

through Figure 6--11).

Table 6--12. Ready Timing For Externally Generated Wait-States Timing Requirements†

MIN

MAX

UNIT

tsu(RDY)

Setup time, DSP_READY before DSP_CLKOUT low

th(RDY)

Hold time, DSP_READY after DSP_CLKOUT low

tv(RDY)MSTRB

Valid time, DSP_READY after DSP_MSTRB low‡

4H--11

th(RDY)MSTRB

Hold time, DSP_READY after DSP_MSTRB low‡

tv(RDY)DSP_IOSTRB Valid time, DSP_READY after DSP_IOSTRB low‡

5H--11

th(RDY)DSP_IOSTRB Hold time, DSP_READY after DSP_IOSTRB low‡

tv(MSCL)

Valid time, DSP_MSC low after DSP_CLKOUT low

1.5

11.5

tv(MSCH)

Valid time, DSP_MSC high after DSP_CLKOUT low

1.5

11.5

† The hardware wait-states can be used only in conjunction with the software wait-states to extend the bus cycles. To generate wait-states using

DSP_READY, at least two software wait-states must be programmed.

‡ These timings are included for reference only. The critical timings for DSP_READY are those referenced to DSP_CLKOUT.

DSP_MSC

DSP_MSTRB

DSP_READY

DSP_A[19:0]

DSP_CLKOUT

tv(MSCH)

tv(MSCL)

th(RDY)

th(RDY)MSTRB

tv(RDY)MSTRB

Wait State

Generated by

DSP_READY

Wait-States

Generated Internally

tsu(RDY)

Figure 6--8. Memory Read With Externally Generated Wait-States

TNETV1002IDZHK 数据表(PDF) 68 Page - Texas Instruments

TNETV1002IDZHK 数据表(HTML) 68 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载