HC705JB2GRSSLASHH datasheet(40/128 Pages) NXP

40 / 128 page

GENERAL RELEASE SPECIFICATION

August 28, 1998

RESETS

MC68HC705JB2

5-2

REV 1.1

5.1

EXTERNAL RESET (RESET)

The RESET pin is the only external source of a reset. This pin is connected to a

Schmitt trigger input gate to provide an upper and lower threshold voltage

separated by a minimum amount of hysteresis. This external reset occurs

whenever the RESET pin is pulled below the lower threshold and remains in reset

until the RESET pin rises above the upper threshold. This active low input will

generate the RST signal and reset the CPU and peripherals. This pin is also an

output pin whenever the LVR triggers an internal reset. Termination of the external

RESET input or the USB reset or LVR are the only reset sources that can alter the

operating mode of the MCU.

NOTE

Activation of the RST signal is generally referred to as reset of the

device, unless otherwise speciﬁed.

5.2

INTERNAL RESETS

The four internally generated resets are the initial power-on reset function, the

USB reset ﬂag reset, the illegal address detector reset and the low voltage reset

(LVR). Termination of the external RESET input or LVR or USB reset or ILADR are

the reset sources that can alter the operating mode of the MCU. The other internal

resets will not have any effect on the mode of operation when their reset state

ends.

5.2.1 Power-On Reset (POR)

The internal POR is generated on power-up to allow the clock oscillator to

stabilize. The POR is strictly for power turn-on conditions and is not able to detect

a drop in the power supply voltage (brown-out). There is an oscillator stabilization

delay of 128 or 4064 internal processor bus clock cycles (PH2) for Ceramic

Resonator or Crystal after the oscillator becomes active.

The POR will generate the RST signal which will reset the CPU. If any other reset

function is active at the end of this 128 or 4064 cycle delay, the RST signal will

remain in the reset condition until the other reset condition(s) end.

5.2.2 USB Reset

The USB reset is generated by a detection on the USB bus reset signal. For

MC68HC705JB2, seeing a single-end zero on its upstream port for 4 to 8 bit times

will set RSTF bit in UIR0 register. The detections will also generate the RST signal

to reset the CPU and other peripherals in the MCU.

Freescale Semiconductor, Inc.

For More Information On This Product,

Go to: www.freescale.com

HC705JB2GRS/H 数据表(PDF) 40 Page - NXP Semiconductors

HC705JB2GRS/H 数据表(HTML) 40 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载