H8SX1663 datasheet(343/1158 Pages) RENESAS

343 / 1158 page

Section 6 Bus Controller (BSC)

Rev.1.00 Jun. 07, 2006 Page 291 of 1102

REJ09B0294-0100

6.12

Idle Cycle

In this LSI, idle cycles can be inserted between the consecutive external accesses. By inserting the

idle cycle, data conflicts between ROM read cycle whose output floating time is long and an

access cycle from/to high-speed memory or I/O interface can be prevented.

6.12.1

Operation

When this LSI consecutively accesses external address space, it can insert an idle cycle between

bus cycles in the following four cases. These conditions are determined by the sequence of read

and write and previously accessed area.

1. When read cycles of different areas in the external address space occur consecutively

2. When an external write cycle occurs immediately after an external read cycle

3. When an external read cycle occurs immediately after an external write cycle

4. When an external access occurs immediately after a DMAC single address transfer (write

cycle)

Up to four idle cycles can be inserted under the conditions shown above. The number of idle

cycles to be inserted should be specified to prevent data conflicts between the output data from a

previously accessed device and data from a subsequently accessed device.

Under conditions 1 and 2, which are the conditions to insert idle cycles after read, the number of

idle cycles can be selected from setting A specified by bits IDLCA1 and IDLCA0 in IDLCR or

setting B specified by bits IDLCB1 and IDLCB0 in IDLCR: Setting A can be selected from one to

four cycles, and setting B can be selected from one or two to four cycles. Setting A or B can be

specified for each area by setting bits IDLSEL7 to IDLSEL0 in IDLCR. Note that bits IDLSEL7

to IDLSEL0 correspond to the previously accessed area of the consecutive accesses.

The number of idle cycles to be inserted under conditions 3 and 4, which are conditions to insert

idle cycles after write, can be determined by setting A as described above.

After the reset release, IDLCR is initialized to four idle cycle insertion under all conditions 1 to 4

shown above.

Table 6.28 shows the correspondence between conditions 1 to 4 and number of idle cycles to be

inserted for each area. Table 6.29 shows the correspondence between the number of idle cycles to

be inserted specified by settings A and B, and number of cycles to be inserted.

H8SX1663 数据表(PDF) 343 Page - Renesas Technology Corp