ZUSBOPTSC01ZACG datasheet(89/282 Pages) ZILOG

89 / 282 page

PS022827-1212

P R E L I M I N A R Y

Operation

Z8 Encore! XP® F082A Series

Product Specification

it is appropriate to have the Timer Output make a state change at a One-Shot time-out

(rather than a single cycle pulse), first set the TPOL bit in the Timer Control Register to

the start value before enabling ONE-SHOT Mode. After starting the timer, set TPOL to the

opposite bit value.

Observe the following steps for configuring a timer for ONE-SHOT Mode and initiating

the count:

1. Write to the Timer Control Register to:

–

Disable the timer

–

Configure the timer for ONE-SHOT Mode.

–

Set the prescale value.

–

Set the initial output level (High or Low) if using the Timer Output alternate func-

tion.

2. Write to the Timer High and Low Byte registers to set the starting count value.

3. Write to the Timer Reload High and Low Byte registers to set the reload value.

4. If appropriate, enable the timer interrupt and set the timer interrupt priority by writing

to the relevant interrupt registers.

5. If using the Timer Output function, configure the associated GPIO port pin for the

Timer Output alternate function.

6. Write to the Timer Control Register to enable the timer and initiate counting.

In ONE-SHOT Mode, the system clock always provides the timer input. The timer period

is computed via the following equation:

CONTINUOUS Mode

In CONTINUOUS Mode, the timer counts up to the 16-bit reload value stored in the

Timer Reload High and Low Byte registers. The timer input is the system clock. Upon

reaching the reload value, the timer generates an interrupt, the count value in the Timer

High and Low Byte registers is reset to 0001H and counting resumes. Also, if the Timer

Output alternate function is enabled, the Timer Output pin changes state (from Low to

High or from High to Low) at timer Reload.

Observe the following steps for configuring a timer for CONTINUOUS Mode and initiat-

ing the count:

1. Write to the Timer Control Register to:

–

Disable the timer

–

Configure the timer for CONTINUOUS Mode

ONE-SHOT Mode Time-Out Period s



Reload Value Start Value

–

Prescale



System Clock Frequency Hz



------------------------------------------------------------------------------------------------------------------

ZUSBOPTSC01ZACG 数据表(PDF) 89 Page - Zilog, Inc.

ZUSBOPTSC01ZACG 数据表(HTML) 89 Page - Zilog, Inc.

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载