| 数据搜索系统,热门电子元器件搜索 |
|
ZUSBOPTSC01ZACG 数据表(PDF) 215 Page - Zilog, Inc. |
|
|
|||||||||||||||||||||||||||||
ZUSBOPTSC01ZACG 数据表(HTML) 215 Page - Zilog, Inc. |
|
215 / 282 page ![]() PS022827-1212 P R E L I M I N A R Y Crystal Oscillator Z8 Encore! XP® F082A Series Product Specification 198 Crystal Oscillator The products in the Z8 Encore! XP F082A Series contain an on-chip crystal oscillator for use with external crystals with 32kHz to 20MHz frequencies. In addition, the oscillator supports external RC networks with oscillation frequencies up to 4MHz or ceramic reso- nators with frequencies up to 8MHz. The on-chip crystal oscillator can be used to generate the primary system clock for the internal eZ8 CPU and the majority of the on-chip periph- erals. Alternatively, the XIN input pin can also accept a CMOS-level clock input signal (32kHz–20MHz). If an external clock generator is used, the XOUT pin must be left uncon- nected. The Z8 Encore! XP F082A Series products do not contain an internal clock divider. The frequency of the signal on the XIN input pin determines the frequency of the system clock. Although the XIN pin can be used as an input for an external clock generator, the CLKIN pin is better suited for such use (see the System Clock Selection section on page 193). Operating Modes The Z8 Encore! XP F082A Series products support four oscillator modes: • Minimum power for use with very low frequency crystals (32kHz–1MHz) • Medium power for use with medium frequency crystals or ceramic resonators (0.5MHz to 8MHz) • Maximum power for use with high frequency crystals (8MHz to 20MHz) • On-chip oscillator configured for use with external RC networks (<4MHz) The oscillator mode is selected via user-programmable Flash option bits. See the Flash Option Bits chapter on page 159 for information. Crystal Oscillator Operation The XTLDIS Flash option bit controls whether the crystal oscillator is enabled during reset. The crystal may later be disabled after reset if a new oscillator has been selected as the system clock. If the crystal is manually enabled after reset through the OSCCTL Reg- ister, the user code must wait at least 1000 crystal oscillator cycles for the crystal to stabi- lize. After this, the crystal oscillator may be selected as the system clock. Note: |
|
链接网址 |
| ALLDATASHEET是否为您带来帮助? [ DONATE ] |
关于 Alldatasheet | 广告服务 | 联系我们 | 隐私政策 | 数据表链接 | 链接交换 | 制造商名单 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |