STR720 datasheet(217/401 Pages) STMICROELECTRONICS

217 / 401 page

STR720 - CONTROLLER AREA NETWORK (CAN)

217/401

Test Register (CAN_TESTR)

Address Offset: 14h

Reset value: 0000 0000 R000 0000 b (R:current value of RX pin)

Write access to the Test Register is enabled by setting the Test bit in the CAN Control

≠ “00” disturbs message

transfer.

7654

Reserved

Res

rrw

Bits 15:8

Reserved

These are reserved bits. These bits are always read as ‘0’ and must always

be written with ‘0’.

Bit 7

Rx: Current value of CAN_RX Pin

0: The CAN bus is dominant (CAN_RX = ‘0’).

1: The CAN bus is recessive (CAN_RX = ‘1’).

Bit 6:5

Tx[1:0]: CAN_TX pin control

00: Reset value, CAN_TX is controlled by the CAN Core

01: Sample Point can be monitored at CAN_TX pin

10: CAN_TX pin drives a dominant (‘0’) value.

11: CAN_TX pin drives a recessive (‘1’) value.

Bit 4

LBack: Loop Back Mode

0: Loop Back Mode is disabled.

1: Loop Back Mode is enabled.

Bit 3

Silent: Silent Mode

0: Normal operation.

1: The module is in Silent Mode.

Bit 2

Basic: Basic Mode

0: Basic Mode disabled.

1: IF1 Registers used as Tx Buffer, IF2 Registers used as Rx Buffer.

Bits 1:0

Reserved.

These are reserved bits. These bits are always read as ‘0’ and must always

be written with ‘0’.

STR720 数据表(PDF) 217 Page - STMicroelectronics

STR720 数据表(HTML) 217 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载