DRA821U4...ALM datasheet(116/252 Pages) TI

116 / 252 page

Time Stamp definitions and (typical values for reference only):

T0 – All 3.3V voltages start supply ramp-up to VOPR MIN. (0 ms)

T1 – All 1.8V voltages start supply ramp-up to VOPR MIN. (2 ms)

T2 – All core voltages start supply ramp-up to VOPR MIN. (3 ms)

T3 – All RAM array voltages start supply ramp-up to VOPR MIN. (4 ms)

T4 – OSC1 is stable and PORz/MCU_PORz are de-asserted to release processor from reset. (13 ms)

VDDSHVx 3.3V IO domains may have additional ramp-up delay due to following:

Minimizing PMIC power dissipation during low power mode that includes disabling PMIC’s VIO_IN supply for GPIO output buffers.

PDN component turn-on and ramp-up delays needed to isolate MCU and Main IO domains

Any MCU or Main dual voltage IO domains (VDDSHVn_MCU or VDDSHVn) being supplied by 3.3 V to support 3.3-V digital interfaces.

Any MCU or Main dual voltage IO domains (VDDSHVn_MCU or VDDSHVn) being supplied by 1.8 V to support 1.8-V digital interfaces.

VDDSHV5 supports MMC1 signaling for SD memory cards. A dual voltage (3.3/1.8 V) power rail is required for compliant, high-speed

SD card operations. If SD card is not needed or standard data rates with fixed 3.3 V operation is acceptable, then domain can be

grouped with digital IO 3.3-V power rail. If a SD card is capable of operating with fixed 1.8 V, then domain can be grouped with digital IO

1.8-V power rail.

VDDA_3P3_USB is 3.3-V analog domain used for USB 2.0 differential interface signaling. A low noise, analog supply is recommended

to provide best signal integrity for USB data eye mask compliance. If USB interface is not needed or data bit errors can be tolerated,

then domain can be grouped with 3.3-V digital IO power rail either directly or through a supply filter.

VDDA_1P8_<clk/pll/ana> are 1.8-V analog domains supporting clock oscillator, PLL and analog circuitry needing a low noise supply

for optimal performance. It is not recommended to combine digital VDDSHVn_MCU and VDDSHVn IO domains since high frequency

switching noise could negatively impact jitter performance of clock, PLL and DLL signals. Combining analog VDDA_1p8_<phy>

domains should be avoided but if grouped, then in-line ferrite bead supply filtering is required.

VDDA_1P8_<phy> are 1.8-V analog domains supporting multiple serial PHY interfaces. A low noise, analog supply is recommended

to provide best signal integrity, interface performance and spec compliance. If any of these interfaces are not needed, data bit errors

or non-compliant operation can be tolerated, then domains can be grouped with digital IO 1.8-V power rail either directly or through an

in-line supply filter is allowed.

VDDA_0P8_<dll/pll> are 0.8-V analog domains supporting PLL and DLL circuitry needing a low noise supply for optimal performance.

It is not recommended to combine these domains with any other 0.8-V domains since high frequency switching noise could negatively

impact jitter performance of PLL and DLL signals.

VDD_MCU is a digital voltage domain with a wide range enabling it to be grouped and ramped-up with either 0.8-V VDD_CORE or

0.85-V RAM array (VDDAR_xxx) domains.

Minimum set-up and hold times shown with respect to MCU_PORz and PORz asserting high to latch MCU_BOOTMODEn (referenced

to MCU_VDDSHV0) and BOOTMODEn (reference to VDDSHV2) settings into registers during power up sequence.

Minimum elapsed time from crystal oscillator circuitry being energized (VDDA_OSC1 at T1) until stable clock frequency is reached

depends upon on crystal oscillator, capacitor parameters and PCB parasitic values. A conservative 10-ms elapsed time defined by (T4 –

T1) time stamps is shown. This could be reduced depending upon customer’s clock circuit (that is, crystal oscillator or clock generator)

and PCB designs.

Figure 7-5. Independent MCU and Main Domains, Primary Power-Up Sequence

DRA821U-Q1

SPRSP57D – APRIL 2020 – REVISED DECEMBER 2022

www.ti.com

116

Submit Document Feedback

Product Folder Links: DRA821U-Q1

DRA821U4...ALM 数据表(PDF) 116 Page - Texas Instruments

DRA821U4...ALM 数据表(HTML) 116 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载