PC87373 datasheet(2/174 Pages) NSC

2 / 174 page

www.national.com

Revision 1.1

Device-Speciﬁc Information

The following table shows a comparison of features between the PC87372 and the PC87373 devices.

Features

Bus Interface

LPC Bus Interface

— Based on Intel’s LPC Interface Speciﬁcation Revi-

sion 1.0, September 29, 1997

— Synchronous cycles using up to 33 MHz bus clock

— 8-bit I/O read and write cycles

— Up to four 8-bit DMA channels

— Serial IRQ (SERIRQ)

— Reset input (PCI_RESET)

— Optional power-down support (LPCPD)

Configuration Control

— PnP Conﬁguration Register structure

— Compliant with PC01 Speciﬁcation Revision 1.0,

1999-2000

— Base Address strap (BADDR) to setup the address

of the Index-Data register pair (defaults to 2Eh/2Fh)

— Flexible resource allocation for all logical devices:

❏

Relocatable base address

❏

15 IRQ routing options to serial IRQ

❏

Up to four optional 8-bit DMA channels

— Conﬁgurable feature sets:

❏

Software selectable

❏

VSB3-powered pin multiplexing

Legacy Modules

Serial Ports 1 and 2

— Software compatible with the NS16550A and the

NS16450

— Support shadow register for write-only bit monitoring

— Data rates up to 1.5 Mbaud

IEEE 1284-compliant Parallel Port

— ECP, with Level 2 (14 mA sink and source output

buffers)

— Software or hardware control

— Enhanced Parallel Port (EPP) compatible with EPP

1.7 and EPP 1.9

— Supports EPP as mode 4 of the Extended Control

— Selection of internal pull-up or pull-down resistor for

Paper End (PE) pin

— Supports a demand DMA mode mechanism and a

DMA fairness mechanism for improved bus utilization

— Protection circuit that prevents damage to the

parallel port when a printer connected to it is pow-

ered up or is operated at high voltages (in both

cases, even if the PC87373 is in power-down state)

Floppy Disk Controller (FDC)

— Software compatible with the PC8477 (the PC8477

contains a superset of the FDC functions in the

µDP8473, NEC µPD765A/B and N82077 devices)

— Error-free handling of data overrun and underrun

— Programmable write protect

— Supports FM and MFM modes

— Supports Enhanced mode command for three-mode

Floppy Disk Drive (FDD)

— Perpendicular

recording

drive

support

for

2.88 MBytes

— Burst (16-byte FIFO) and Non-Burst modes

— Full support for IBM Tape Drive Register (TDR) im-

plementation of AT and PS/2 drive types

— High-performance digital separator

— Supports fast tape drives (2 Mbps) and standard

tape drives (1 Mbps, 500 Kbps and 250 Kbps)

Keyboard and Mouse Controller (KBC)

— 8-bit

microcontroller,

software

compatible

with

8042AH and PC87911

— Standard interface (60h, 64h, IRQ1 and IRQ12)

— Supports two external swapable PS/2 interfaces for

keyboard and mouse

— Programmable, dedicated quasi-bidirectional I/O

lines (GA20/P21, KBRST/P20)

Function

PC87372

PC87373

Keyboard and Mouse Controller (KBC)

Floppy Disk Controller (FDC)

Parallel Port (PP)

Serial Ports

Serial Port 1 (SP1)

Serial Port 2 (SP2)

MIDI Port and Game Port

General-Purpose Input/Output Ports (GPIO)

System Wake-Up Control (SWC)

Basic Functionality

Last power state indication & Special LED blinking

Fan Speed Control and Monitor

(FSCM)

Fan Speed Monitor (Tacho)

Fan Speed Control (PWM)

Glue Functions

PC87373 数据表(PDF) 2 Page - National Semiconductor (TI)

PC87373 数据表(HTML) 2 Page - National Semiconductor (TI)

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

数据表下载